5.5kw Woodworking CNC Router with Atc 4ftx8FT
|End cap circulate design, high speed, high Dm-N rating with low noise design, |
Unique circulate high lead design to ensure smoothness running performance.
Patent seal system, excellent dust proof ability
Variety of selection in diameter and leads
Zero backlash, high stiffness.
|The trains of balls are designed to a contact angle of 45° which enables it to bear an equal load in radial, reversed radial and lateral directions. Therefore, it can be applied in any installation direction. Furthermore, MSA series can achieve a well balanced |
preload for increasing rigidity in four directions while keeping a low frictional resistance.
This is especially suit to high precision and high rigidity required motion.
The patent design of lubrication route makes the lubricant evenly distribute in each circulation loop. Therefore, the optimum lubrication can be achieved in any installation direction, and this promotes the performance in running accuracy, service life, and Reliability.
|X,Y axis are drived by helical gear which is featured as low noise, fast and strength transmission, accuracy and steady meshing.|
|Leadshine Servo Motor & Shimpo planetary Gearbox, the structure maximizes the torsional moment when motor power is rated, it is for high load and more smooth machining, it offers long-term maintenance-free solution.|
|Ncstudio NK300 control system:|
Ethernet for networking USB flash drive(s) File size capacity up to flash drive size Direct DNC or drip feed capability
Modes: Auto, MDI, Manual operations .MPG for fine manual operations .Tool height-diameter compensation
Work coordinates-offsets .Onboard PLC diagnostic system .Automatic homing operation
|5.5kw water cooling spindle|
|8-position tool station in the rear of the machine. Easy loading and unloading of material from either side of the machine.|
|Better anti-jamming and allowing long distance transmission of signal, with a 3m handwheel cable;|
Accurate pulse output;
Magnetic function available
|Automatic tool length calibration and registration, it allows for easy and accurate "Z" zero position for single and multiple tool changes through the program,saves time & error-free.|
|Central Lubricator, easier to lubricate the ball screws and Guid units regularly, setup once and let it do the rest.|
|Vacuum pump: 7.5kw Regenerative Vacuum pump with motor starters, vacuum gauge, primary and secondary filters, check valve and necessary plumbing to connect to the router. It is available with 220v 380V 50-60Hz, 3 PH or 380V, 50-60Hz.There are other options to be considered. Purchasing a number of smaller pumps can help reduce cost. If you are processing sheets of material that have large parts, then a single pump can be utilized. If the nest has numerous smaller parts, then it is best to run all the pumps for maximum air flow. |
Vacuum table: The vacuum table multi-zoned which allows the operator to easily switch from full sheet processing to smaller part processing. Zones can be turned off easily with the switches on the front of the machine. Gaskets can also be routed to accommodate various material sizes and styles.